Eliminate Leverset Wobble with a Precision Fit

Got a Lockwood 930 or 950 Series leverset that won't sit tight? If your door is under 32mm or you’ve got a tricky commercial fit-out, this 5mm spacer packer is the professional fix. It provides the necessary offset to ensure the rose sits flush and the internal mechanism engages perfectly.

Built for a Solid Install

Standard Lockwood commercial levers are great, but door thicknesses aren't always standard. This 3D printed packer bridges the gap.

• Exact Compatibility: Designed specifically for the footprint of Lockwood 930/950 commercial levers.
• Stable Support: Provides a flat, rigid surface for the lock rose to tension against, preventing "lever sag" over time.
• High-Quality Print: Made from impact-resistant material that won't compress or crack under screw tension.
• Clean Finish: Low-profile design that blends into the lock installation for a professional look.

Why you need this

There's nothing more "amateur hour" than a loose door handle that rattles every time you touch it. If the door is too thin, the thru-bolts bottom out before the lock is tight. Slip one of these 3.5mm packers on, and suddenly that lever feels like it's part of the door. It’s a dead-simple fix that saves you from hacky DIY solutions like using washers or cardboard shims. Get it done right the first time.

I had a steel gate where I could not cut the spring relief needed to packing out saved lost of time!